PI 500 for e.g. portable flow measurement
The new PI 500 for e.g. portable flow measurement is a universal handheld measuring instrument and can be used for many applications in industry.
Details
- New: Unique sensitivity in the lower Measuring range: measures from as little as 2 m/s and thus covers the entire working range of speed-controlled Compressors
- Particularly suitable for extremely high Flow rates
- Flow, Total consumption, Temperature and Pressure
- Measuring at high temperatures, max. temperature 180 °C
- Can be used in pipes from DN 20 to DN 600
- Installation via 1/2" Ball valve under Pressure
- Measuring the Capacity of compressors
- Compressed air audits
- Efficiency measurement of Compressedair systems
- After a functioning Water separator
- In horizontal lines (recommended) or in Risers
- 04...20 mA, pulse and a Modbus RTU (RS 485) interface as standard
- Optional interfaces such as Modbus TCP (Ethernet), PoE, M-Bus
- Pressure range up to 30 bar
- Medium temperature -30 °C ... +180 °C
- Integrated Display to show the Measured values
- Can be used from DN20 to DN500
- Simple installation under pressure
- Settings can be adjusted using the buttons on the display
- Main counter reading can be reset via the Display
- Can be used for Velocities up to 600 Nm/s
- Highly accurate with an Accuracy of 1.5% of Measured value
Similar products
Intelligent chart recorder DS 500 for compressed air and gases
Intelligent chart recorder with up to 12 sensor inputs. 7" colour display with touch panel.
Chart recorder - DS 400
Tried and tested Chart recorder with 3.5" graphic display with touchscreen. Integrated Data logger option. Up to 4 sensor inputs. Optional Ethernet/ RS 485 interface.
Intelligent mobile chart recorder - DS 500 mobile
Portable solution for Consumption measurement, Leak calculation and energy analysis for Compressed air / gases according to DIN EN ISO 50001.
Accessories
Spot drilling collars
If there is no measuring point with a 1/2" Ball valve on existing pipework, a measuring point can be set up quickly and inexpensively using Spot drilling collars.
Drilling jig for set up a measuring site
This Drilling jig can be used to set up a measuring site after welding on a 1/2" threaded socket and then installing a 1/2" Ball valve.
High-pressure protection
This additional device is used to install CS sensors from the VA 500 series under Pressure and to fix them securely in place.